Description
Retro AR15 Extended Flash Hider 1/2-28 – 6 InchKAK Industries was inspired by and designed retro AR 15 Extended Flash Hider from the XM-177 Moderator. There are many uses, but the primary idea behind this flash hider is to extend a 10.5″ barrel to legal non-NFA length (when pinned and welded). This flash hider is a touch on the heavy side, but that stands to reason as it is heavy duty and machined from bar steel. Similar to an A2, it has 5 ports on the top and sides with no gas ports on the bottom. It only requires a 3/4″ wrench to install by hand, plus it has a predrilled 0.125″ hole in place for anyone who wishes to pin and weld it in place.FeaturesCNC machined from bar steelHeat treated for strengthPhosphate coated to protect from corrosionThreaded 1/2-28Bore sized for use on both 5.56mm and 9mm barrels6.15″ over all length1.0″ diameterAdds approximately 5.56″ to overall length of barrel when pinned and welded..125″ hole pre-drilled for pin and weldWeight: 9.7ozRequires standard .750″ wrench for installation
